![]() In the next post, I will cover using the Ublox eval software to talk to and configure the receivers before we start using RTKLIB. The board can now be connected to the PC with a USB cable, making sure you have the right connector for the UART board you are using, in this case, a mini-USB connector for the Sparkfun board.ĭo this for both receivers and connect both to your laptop. You can't see in the photo, but I soldered the connecting wires directly to the GPS receiver board and the other ends to a four pin header which I then plugged into the connector on the back of the FTDI board. To connect the two boards requires four wires. Here's a couple stock photos of the board I use.Īnd here is the FTDI board connected to my receiver and antenna. The RX/TX lines on the u-blox receivers are 3.3 volt and are not tolerant of 5 volts so be sure you choose the correct board (see my note at the end of the post). ![]() If I place an order in the morning, I can pick it up in the afternoon, which is very convenient (and avoids any shipping charges). I use this one because Sparkfun happens to be a few miles from my house. There are many similar boards available, some are definitely less expensive. I am using a USB to UART converter board (FTDI) from Sparkfun to do this. If you are using M8N receivers with a UART interface rather than USB then it is a bit more complicated since we need to first convert the UART signals to USB. In that case you are done and can skip to the next post. If you use the M8T receivers from CSG with a USB interface that I suggested in my last post, then this step is trivial, just use two USB cables to connect the receivers to the laptop. There are other ways to get base station data that would allow you to use only one receiver, especially if you are doing post-processing rather than real-time positioning, but for these tutorials, I will assume you are using two receivers. I did all my initial testing with two receivers, one as the base station reference and one as the rover. It's OK to get everything configured on the laptop in the house, but be sure to choose a location with open skies away from buildings and trees when your ready to collect your first real data. You will not get usable data if you try to collect data inside a building, so don't waste time trying this on a desktop computer. For testing though, the simplest way to get started is to plug both receivers directly into the USB ports of a laptop. ![]() For practical use, most likely you will want to eventually connect the GPS receivers to battery powered low cost single board computers, such as a Raspberry Pi or Beaglebone, to make them portable and stand-alone.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |